Fermacell® Floor Glue Greenline | 1kg Bottle

Fermacell® Floor Glue Greenline | 1kg Bottle

The fermacell® greenline Floor Glue is a label-free, non-foaming, dispersion based, single-component adhesive, which hardens through the evaporation of water viscoplastic.

Easy to apply - the special twin nozzles ensure that the correct amount of glue and placement on the joint edge.
As an alternative to fermacell® Floor Glue, greenline Flue Glue may be used.

Shake fermacell® greenline Floor Glue before use.

The rebated edges of the fermacell® Flooring Elements are glued with fermacell® greenline Floor Glue.

Two glue strings (diameter approx. 5mm) are applied to the edges for this purpose.

This takes place in a single step due to the special twin nozzles.

The next element should be fitted and glued in the perimeter area within 10 minutes, so that the glue fully fills and oozes out of the joint.

This serves to ensure the complete wetting/penetration of the glue to the butt-joints.

In order to ensure the necessary contact pressure, one's own body weight is applied to the upper fermacell® Flooring Element and it is then screwed with fermacell® screws or stapled to the lower element with special diverging staples.

The maximum adhesive joint width is 2mm.

After approx. 5-30 minutes, the excess glue should be removed with a fermacell® glue scraper, a spatula or a chisel.

The surface should then not be walked-on for the next 24 hours.

Hardened glue (>24 hours dry) can be removed with a fermacell® glue scraper or chisel.

The laid surface can be walked-on after approx. 24 hours at a normal indoor climate of 20°C and 50% humidity.

After approx. 72 hours, the full load-bearing capacity is achieved

Remove excess glue after 5-30 minutes with a scraper.

Do not walk on the surface for 24hrs.

Leave to cure for this time at an ambient indoor climate of 20°C and 50% RH.

Remove any hardened glue.

After 73 hours the full load bearing capacity of the flooring element joints are achieved.